HILLS® Series LED Code Pad User Manual

HILLS® Series LED Code Pad User Manual #

Introduction #

Not all features may be available on your system. Check with your installer to find out which features are programmed for use.

Table of Contents #

• Code Pad Diagrams
• Glossary of Terms
• Understanding the Code Pad Lights
• Code Pad Control Tones
• Fully Arming the System – On Mode
• Fully Arming the System – Quick Arm Mode
• Partially Arming the System – Partial Mode
• Disarming the System
• Bypassing Individual Zones
• Group Bypass
• Changing & Adding User Codes
• Deleting User Codes
• Walk Test
• User Code Authorization
• Setting the Door Chime
• Exit Mode – Extend Exit Timer
• Code Pad Emergency Keys
• Viewing Alarm Memory
• Reset Latched Alarms
• Setting System Date and Time
• Programming Telephone Numbers
• Viewing Telephone Numbers
• Deleting Telephone Numbers
• Communicator, Battery & Siren Test
• Service Light
• Emergency Evacuation Plans
• Warranty Statement

Detailed Instructions #

Fully Arming the System (On Mode):

1. Ensure all protected doors and windows are closed. The ‘ready’ light will indicate when the system is ready to arm.
2. Enter your 4-digit user code to arm the system. The ‘armed’ and ‘exit’ lights will illuminate, indicating you may exit the premises.

Partially Arming the System (Partial Mode):

1. Suitable for when you are at home but want the exterior doors and windows armed.
2. Press the [PARTIAL] key. The system arms the perimeter while the interior can still be accessed without triggering the alarm.

Disarming the System:

1. Upon re-entering the protected area, the code pad will sound a continuous tone. Enter your user code to disarm.

Bypassing Zones:

1. To bypass one or more zones, ensure the system is disarmed, then enter the bypass command and zone numbers.

Changing User Codes:

1. To change or add user codes, the system must be disarmed. Enter the master code followed by the new user code.

Service and Maintenance:

1. The service light will indicate if the system requires maintenance. Press the [*] key followed by the [2] key to diagnose issues.

Download the PDF Version : Hills-DAS-LED-Code-Pad-User-Manual